MicroSquirt.com read only forum (Jan.15,2018)

here is the log file.

Hey. Running MS-II, v3, 2.36
EDIS-4 with 36-1 wheel

Has anyone experienced a faulty pickup on EDIS?
I have some strange drops in engine performance, wich result to one run with one small drop, one with several severe drops, and the next run is clean as a whistle. I have tried to adjust the gap ...

460stang;
Upon looking at your log file, I think your problem is related to alternator disturbance. Have you tried to disconnect your alternator, and then take a test run?
I had similar disturbance, but got rid of it by installing a capasitor on the alternator, and a regular ice filter on the MS ...

Thanks man. There was somethings I havn't thought of.. I'll see into this in a couple of days, and post back here with result. Found the prob with uploading the log file, as you can't upload bigger than 1,5MB. I do not have a smaller file though, so I'll try to log again tomorrow, and post it then.

This is most definatly load dependant, or so it seems. I have been thinking of the fact that it's there all the time, but you will fell the drops more violent if you add more load. I agree though, but I'm not so sure that load is the factor.... the most annoying part of it all, is that it's ...

I doubt this has anything to do with the beta code. I run 2.36 with same result. Tried 2.86 with no change. Also re-flashed 2.36 several times.
I am led to believe that the problem is somewhere inside MS, as i get an engine bit zero when the drop accours. This is no re-set though, because all other ...

please someone, look at this one!
I have the exact same problem, exept I have it all the time at appx 6000rpm, at boost!
Does anyone have an opinion?
Wasn't able to attach a log file. will try again.

You are saying that enginebit are showing something that has to do with accel enbrichment.
upon looking at my current program, this feature is disabled. ( I am not the one responsible for programming)
Is ther ea guide on how to set this up?
the scroller is on the far left side (map based) and all ...

thanks alot. Will try this tomorrow.
I had alot of noise before, with tons of resets. Have put in noise supressor before MS, before edis, and before coil. Also replaced edis capasitor, and put capasitor on alternator. alså "star" grounded the engine.
But good point in this being noise from ignition ...

System is V3 MSII FW 2.36 and EDIS4

Can anyone check out this log and give a reply on what can cause these spikes, have tried to disconnect the alternator and there is no difference. Had a lot of noise that we got rid of by using multiple noise supressors and caps. Please help.....