First of all i would like to so say "hi" since this is my very first post on this forum. I am kind of new to the efi thing so i would like to have confirmation of my plans on installation.
I want to run a Microsquirt V3 on a Toyota Starlet 4EFE engine. The Distributor has 4 wires which are:
- IGF (Ignition feedback from Ignitor Coil)
- IGT (Igniton Timing)
- NE-
- NE+
Inside the Distributor there is a 4 tooth wheel with one VR Sensor.
Looking at the schematics i wire:
VR1IN+ to NE+
VR1IN- to NE-
IGNITION Output#1 to IGT
IGF (Ignition feedback from ignitor coil) remains unused
Can someone confirm this ?
Greetings from Germany
Markus
Wiring ignition to Toyota Distributor
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
-
Matt Cramer
- Super Squirter
- Posts: 910
- Joined: Sat Jul 03, 2004 11:35 am
Re: Wiring ignition to Toyota Distributor
Thanks for your reply!
Greetings
Markus
Greetings
Markus