well now i have another problem i had my car running and all the sudden i lost all rpm signal to the MS i checked all the wiring and the control module and all that checked out.
the tach was reading off since i first started the car up and i only have like 30 miles on this thing. and also i have a weird problem with the O2 sensor in the MS ???????????????????
is there somthing that could of burned out?
i have a ms II 3.0 with a relay board
tach signal problem
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
tach signal problem
I had a similar problem where I had my car running and after I shut it off and tried to start it again, there was no tach signal. I ended up just reloading the code into the processor and it started up again. I haven't had a problem with it since so I'll keep my fingers crossed.
-------------------- m2f -------------------- This post is at: http://www.msefi.com/viewtopic.php?p=135001#135001 -------------------- m2f --------------------
Posted by email.
-------------------- m2f -------------------- This post is at: http://www.msefi.com/viewtopic.php?p=135001#135001 -------------------- m2f --------------------
Posted by email.