MicroSquirt.com read only forum (Jan.15,2018)

if you want to compare notes, you can call me at (719) 570-9595 or email me at benfox@foxperformanceengines.com

I feel this project has a lot of potential, as any 1.6 ecm or older p7/p8 computers are turds to say the least. and burning chips for them is ridiculous and archaic in my opinion.

im ...

The horizontal front cylinder is considered #1, so that's what im useing as my base.

The front cylinder has always been considered #1 by ducati and that's what they base all their ecm mapping off of, stock ducati ecm's have one main fuel map, thats the mapping for both cylinders, then they have a ...

well i tried that it didn't help.

any more ideas on this? thanks

i willl try that again, i thought i did it but maybe i wasn't doing it the right way.

what is the procedure for this?

at no time were the coils hooked up when this problem arose.

well as I was testing last night after I made my first post about being close to maybe trying it out on an actual running bike, something happend and im not sure what.

at somepoint the laptop lost contact with the MS and wouldn't connect.

but it appeared as though the MS would still work, because ...

Well, I am still reluctant to try to run the ducati as of yet.

Currently, I have set up on the bench two injection systems: 1. the mircrosquirt system with all the ducati injectors, sensors etc...
2. another stock ducati ecm/ harness injectors etc...

I have good steady crank signal and RPM from ...

I got the MSII all wired up, have all the sensors reading right etc...

I have a steady RPM signal from a cam wheel (48 teeth total 2 missing teeth)

This is a Ducati engine 90 degree vtwin, but these are not the cigar coils, they are the older late 90's coils they look similar to Ford mustang ...

Thanks, i have been checking my in box but haven't got any messages.

I'll send you a new PM here now.

does anyone know what I can do to get this thing fixed?

Where I can send it to?

Anything?

Thanks for the reply, i assumed that i was at a point where something needed fixed, since it had no 5v ref.

btw I am not using a usb adaptor, and I have tried all the different baud rate settings. thought i stated that above but maybe not.

anyone heard from Bruce lately? i sent him some pms about ...