Module board height

For engine experimenters, the MicroSquirt® PCB is offered in a module format with enhanced capabilities to be plugged into other boards. This is the place to discuss the MicroSquirt Module.
Forum rules
Post Reply
dontz125
Master Squirter
Posts: 375
Joined: Mon Jun 29, 2009 1:00 pm
Contact:
Contact dontz125

Module board height

Post by dontz125 »

Ok, me again with the weird questions... :lol:

I have an idea going through my head for a mounting arrangement that I think would work very nicely, but the box dimensions are awful darn close; I'm shaving fractions of a mm here...

I've found the length and width of the uSM PCB; I cannot for the life of me find the height. Could some kind soul please figure out the minimum headroom needed for one of these boards, and let me know?

TIA,

Don
Top
24c
Master Squirter
Posts: 593
Joined: Sat Feb 16, 2008 12:15 pm
Location: Chorley, Lancashire UK
Contact:
Contact 24c

Re: Module board height

Post by 24c »

The tallest component, circled in yellow, on my module board is approximately 3.5mm above the circuit board, but I don't have any pin out connectors attached to the 50 pin or the 10 pin J1 connector.
MicroSquirt_snap.png
MicroSquirt_snap.png (164.2 KiB) Viewed 2027 times
Top
dontz125
Master Squirter
Posts: 375
Joined: Mon Jun 29, 2009 1:00 pm
Contact:
Contact dontz125

Re: Module board height

Post by dontz125 »

Perfect - thank you!
Top
Post Reply

Return to “MicroSquirt Module”