Hi all,
got myself a laptop the other week and I've been setting up a system on it for when I'm ready to tune my car. I've compiled megatunix-0.9.23 on FreeBSD and it went fairy smoothly. Megatunix runs, but keeps segfaulting. If I tell it to run off-line and then like on VE TABLE it terminates and leaves a core dump. Is this unusual behavior? I'm thinking I might have to run a Linux binary under emulation of I can't get it fixed.
Segfault on VE TABLE
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
-
anonymous.shyster
- Helpful Squirter
- Posts: 75
- Joined: Fri Oct 21, 2011 9:46 pm
-
anonymous.shyster
- Helpful Squirter
- Posts: 75
- Joined: Fri Oct 21, 2011 9:46 pm
Re: Segfault on VE TABLE
Didn't sort out the segfault issue with 0.9.23 but I was able to sort out the problems I was having with the latest version which is available via a git repository (it identifies as 0.9.24). I haven't noticed any segfaulting issues like I experienced with 0.9.23 and 0.9.22.