Hi.
I'm in the process of wiring my Microsquirt, and i have a thick grey wire with IGN written on it. But i can't find it in the wiring diagram, can anyone tell me what this goes to?
Thanx
Arild
Wire question
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
-
24c
- Master Squirter
- Posts: 593
- Joined: Sat Feb 16, 2008 12:15 pm
- Location: Chorley, Lancashire UK
- Contact:
Re: Wire question
That wire is the co-axial wire for the crank sensing circuit. In my case it is VR1+ & VR1-, as I am using a VR sensor at the crank.
You can find this under "wiring" under the microsquirt.info pages, snap shot below...
Hope this helps.
You can find this under "wiring" under the microsquirt.info pages, snap shot below...
- thick_grey_wire.png (20.11 KiB) Viewed 822 times