Microsquirt "header" info?
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
Microsquirt "header" info?
I am designing an adapter board that will allow me to plug the MS(V3.0) directly into My existing wiring harness. I was thinking that it would be a good idea to just use the .100 header of the microsquirt ( header version ) rather than the DB37 so that I can upgrade to the smaller Microsquirt when it comes available.Has the pin-out been astablished yet for the header?