MicroSquirt.com read only forum (Jan.15,2018)

I'm looking to use a mapdaddy with my microsquirt, and I am putting it in a separate little box.
I already have the map sensor working using the first 3 pins and the first sensor.

For baro though, are the next 3 pins for the second sensor in the same order as the first 3, or do I just use the baro out connection from the board and ignore the other 3 pins?

Thanks,
Jeff

The other three pins are not for the sensor but are a set of mechanical support pins. Use the bar out hole on the board itself.

Thanks Matt, yeah I decided the best way was to just solder a wire to baro out and see if it gave me a signal.
And it did!