Programming Microsquirt CPU

This forum is for discussion of MicroSquirt (TM) from Bowling and Grippo. The MicroSquirt information site is at www.usEasyDocs.com
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
Post Reply
Mangusta
MegaSquirt Newbie
Posts: 1
Joined: Wed May 05, 2004 1:42 pm
Location: South Africa

Programming Microsquirt CPU

Post by Mangusta »

Hi all

Maybe this question has been asked. I need to know if I will be able to program the new MC9S12C64 CPU myself like the old 68HC908 CPU. I know the new chip is supersmall. But say I can mount it, can it be done? Will I need to program it before soldering it onto the PCB or can I program it after it's fitted?

Regards,

Mangusta
South Africa
Top
Bernard Fife
Super Squirter
Posts: 1009
Joined: Mon Feb 16, 2004 3:15 pm

Post by Bernard Fife »

Mangusta,

You can prgram a blank chip after installing it using a BDM cable. For all the MicroSquirts though, the chip will already be programmed, and the code can be upgraded through the serial port.

Lance.
Top
Post Reply

Return to “MicroSquirt General Information”