MicroSquirt.com read only forum (Jan.15,2018)

Need help with accel enrichment and upper end tunning. The car buckles under hard accel. and on the top end of 5000 rpm and 120kpa. I have tried to richen bins but no success. map side set at 3,6,9,14 and tps side set at 3 6 9 14 with 90% tps. do have last log attached. MSII v3.0 2.36 firmware on a gm 3.1 7pin hei throttle body with 8 lbs of boost. do I need to set the kpa bins in ve table higher to match recorded map?

"do I need to set the kpa bins in ve table higher to match recorded map? "

I have been setting my highest cells on my tables to a KPA that I dont plan on reaching.
THat way I can set fuel and timing to extrapolate to the higher kpa.

If you plan on running 120 kpa.... I would set my top 2 values at 120 KPA and 140 KPA....
That way if you overshoot for whatever reason you have it covered.

Can you post an MSq.

Your accel enrichments seem a little high to me...... but it depends on setup thats for sure.

P.S and friends dont let friends tune boosted vehicles with narrow band.

Hopefully this is the correct file, I am new to the posting thing. I hear you on the narrow band, wide band sensor on the way. If you see anything I need to correct I would appreciate any advice.

Thanks
Blatzy