Page 1 of 1
What output on a MSII V3 can I use for a cooling fan.
Posted: Sun May 14, 2006 7:20 pm
by IcantDo55
I been searching the forum and can't find the answer. Its going to trip a 75amp relay for the cooling fan. The output from the MS is going to ground to turn it on, right?
Thanks and sorry for the stupid questions. There will be more soon, I should be fireing it up shortly.
Posted: Sun May 14, 2006 7:37 pm
by krisr
I'm using the FIDLE pin to switch negative to 2 x 40A relays for my cooling fans. So far haven't had an issue. Make sure you use the code v2.36 and configure it up in the spare ports part of Megatune.
Posted: Mon May 15, 2006 5:35 am
by IcantDo55
krisr wrote:I'm using the FIDLE pin to switch negative to 2 x 40A relays for my cooling fans. So far haven't had an issue. Make sure you use the code v2.36 and configure it up in the spare ports part of Megatune.
Thanks
Posted: Mon May 15, 2006 7:25 am
by Bernard Fife
I been searching the forum and can't find the answer.
IcantDo55,
In general, you should search the manual as well:
http://www.megamanual.com/mtabcon.htm. In this case, you would find the spare outputs under MS-II at:
http://www.megamanual.com/ms2/spare.htm
Lance.