thermo fan control
Posted: Fri Mar 31, 2006 4:00 am
G'day
I wasn't sure where to put this so i thought it would be safe to ask here.
I'm going to be running ms-2, tfi, ford pwm idle control, lc1 wideband and a relay board.
I want to run twin thermo fans from ms-2 using either pt6 or pt7. How would i connect these to the spare db37 pins when i make my cable to go to the relay board? Which pin on the terminal strip on the relay board will it come out on?
When i change the port settings do i do the following:
port: pt6-iac1
Variable: coolant greater than
Threshold 90 Hysteresis 10
No second condition
Power on value 0
Trigger value 0
Does this sound right. All i need to do is switch a relay on. Is there anything else i would have to do, like add a transistor.
Cheers from aus
I wasn't sure where to put this so i thought it would be safe to ask here.
I'm going to be running ms-2, tfi, ford pwm idle control, lc1 wideband and a relay board.
I want to run twin thermo fans from ms-2 using either pt6 or pt7. How would i connect these to the spare db37 pins when i make my cable to go to the relay board? Which pin on the terminal strip on the relay board will it come out on?
When i change the port settings do i do the following:
port: pt6-iac1
Variable: coolant greater than
Threshold 90 Hysteresis 10
No second condition
Power on value 0
Trigger value 0
Does this sound right. All i need to do is switch a relay on. Is there anything else i would have to do, like add a transistor.
Cheers from aus