MicroSquirt.com read only forum (Jan.15,2018)

Im planning a MS-II on my z32 TT. I believe going with the ford edis is the easiest to use due to the fact you dont have to mess with dwell control and its just so damn simple. anyone have it on thiers that can give me some pointers, morely where to put the 36-1 tooth plate on the crank pully. im assuming the missing tool goes right at the 0 degrees TDC mark?

thanks
thomas

Thomas,
Nice car! You can put the missing tooth wherever you want it as long as the sensor is mounted in the proper place in relation to that gap.

allen