MicroSquirt.com read only forum (Jan.15,2018)

Ok, first off, I need to know:

1) max current that can be sourced per injector bank (mm says to try to keep it around 1 amp, current config would be around 4 amps!)

2) should I use resistors or PWM to limit the current?

This is for a v6, 3 injectors per bank.

Thanks!

I would use resistors, PWM causes trouble for some people (including me) on V3 boards. 10 ohms times three is a lot of current, so I don't think using nothing is a good idea.