oke guys i'm new here this me be a stupid question but anyway
i'm going to by the ms1 v3 but at the same time i woudl li to buy a wideband so i can tunethe car anyway i saw this on ebay is this all i need just plug i in on the ms1?
eBay ads NOT allowed on these forums/ebaymotors/ws/eBayI ... AMEWA%3AIT
or do i need this one?
eBay ads NOT allowed on these forums/ebaymotors/Innovate ... QQtcZphoto
any help would be gr8 thnx
newbie question
Forum rules
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
-
Fastest95PGT
- Helpful Squirter
- Posts: 61
- Joined: Sat Jun 12, 2004 5:27 pm
- Location: Worcester, MA
- Contact:
Re: newbie question
That is just a sensor. You need a WB controller to use it, it doesn't just plug in to your stock harness.
That is a sensor AND controller. This will work with MS as long as you configure one of the LC-1 controller's outputs to be 0-5V 10-20 A/F. There are a lot of threads discussing this and the directions are pretty well laid out so you can read those once you get it.
1995 Ford Probe GT ~ Megasquirted & Boosted
275whp/242wtq @ 5.5psi ---- 317whp/287wtq @ 8.5psi
^^^ (thanks to MSnS-E and dyno tuning by me!)
2003 GSX1300R (Hayabusa)
275whp/242wtq @ 5.5psi ---- 317whp/287wtq @ 8.5psi
^^^ (thanks to MSnS-E and dyno tuning by me!)
2003 GSX1300R (Hayabusa)