PMW Idle solenoid issue?

wes kiser · Post by **wes kiser** » Tue Jan 17, 2006 5:03 am

I am in the process of stim testing my ms2, and everything appears fine except the pwm idle. THe fidle light just stays on, and doesn't go out. I have set it up in the software to have a duty cycle of 0 when warm. I think when I added the tp120, I may have "reversed" it. Do all tp120's have the same pin out (I didn't look at the package to see what was E,B, and C, I just hooked it up like it was shown in the pcb v 3.0 assembly guide. Also, I am assumeing that as it goes from a high duty cycle to a low one the light will dim?

wes kiser · Post by **wes kiser** » Wed Jan 18, 2006 5:15 am

I figured it out, apparently the duty cycle works reverse of what I thought (at 100% duty cycle the light is off, @0% it is bright, and in the middle dims it).