PS Never scoped this so I don't know what it'd produce.
converting my banshee to efi
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
-
24c
- Master Squirter
- Posts: 593
- Joined: Sat Feb 16, 2008 12:15 pm
- Location: Chorley, Lancashire UK
- Contact:
Re: converting my banshee to efi
I just wonder whether you could use an inductive clamp like is found on a timing light to act as a tach signal or maybe a few coils of wire wrapped around the HT lead, like a simple kart RPM meter pick up? Obviously as your engine has a varied ignition advance built into the ignition, the crankshaft positional value would be changing, but maybe you could get a tach signal from this to drive the fuelling.
PS Never scoped this so I don't know what it'd produce.
PS Never scoped this so I don't know what it'd produce.