Hi, I'm a bit lost and confused with the 'shield' in this diagram http://www.megamanual.com/ms2/edis4ew.gif
A shield is shown, coming from pin 7 on the EDIS module, and doing a loop around the other wires. I don't understand what this is supposed to signify as I've never seen this in a wiring diagram before. No mention of it in the text on the page, just in the image.
http://www.megamanual.com/ms2/EDIS.htm
Wiring EDIS
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
-
anonymous.shyster
- Helpful Squirter
- Posts: 75
- Joined: Fri Oct 21, 2011 9:46 pm
Re: Wiring EDIS
I found something that said that the wires with the loop around them in the diagram should be shielded. It was suggested to wrap them in tin foil, which I suppose is then connected to the shield pin? Is this correct?