4 High Impedance Injectors Per Driver
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
4 High Impedance Injectors Per Driver
I know this is listed as acceptable, but is anyone actually using 4 injectors per driver?
2.3t Swapped RX-7, s200g turbo, ms3 sequential, LS2coils
-
Bruce Bowling
- Site Admin
- Posts: 285
- Joined: Mon Feb 16, 2004 4:25 pm
- Location: Baltimore, MD
Re: 4 High Impedance Injectors Per Driver
Yes, I have been running this on a SBC with microsquirt for about 3 years. The injectors are 12 ohm Bosch standard injectors, when they are hooked 4 in parallel the resistance is in the 3 ohms range. The drivers on microsquirt have no problem with this load at all and operate with no heat.wes kiser wrote:I know this is listed as acceptable, but is anyone actually using 4 injectors per driver?
- Bruce