Communication help please

Captain Midnight · Post by **Captain Midnight** » Thu Jul 22, 2010 9:09 am

It calls it: Communications Port (Com1)

Captain Midnight · Post by **Captain Midnight** » Thu Jul 22, 2010 9:37 am

The port checker can't see Microsquirt. I have checked the cable.

Captain Midnight · Post by **Captain Midnight** » Thu Jul 22, 2010 9:41 am

Is there any other way to test. I'm getting nothing.

Captain Midnight · Post by **Captain Midnight** » Thu Jul 22, 2010 8:56 pm

I can't get any comunication with Microsquirt. Should I send it back, or is there a way to check it.

Matt Cramer · Post by **Matt Cramer** » Fri Jul 23, 2010 4:48 am

Please post the text you get when you try to load the firmware on COM1 instead of COM3.

Captain Midnight · Post by **Captain Midnight** » Sat Jul 24, 2010 1:42 pm

If I set Megatune to port 1, port-checker say it found port 3. If I set Megatune to port 3, port-checker says it found port 1. What is that all about?

mxrob · Post by **mxrob** » Sun Jul 25, 2010 4:40 am

Have you just tried dumping and reloading code?

Captain Midnight · Post by **Captain Midnight** » Sun Jul 25, 2010 8:18 am

The instrustions in the manual don't work, so how would you you do that?
Thanks

Matt Cramer · Post by **Matt Cramer** » Mon Jul 26, 2010 9:11 am

Captain Midnight wrote:If I set Megatune to port 1, port-checker say it found port 3. If I set Megatune to port 3, port-checker says it found port 1. What is that all about?

Don't run MegaTune and Port Check at the same time.

MicroSquirt.com read only forum (Jan.15,2018)

Communication help please

Re: Communication help please

Re: Communication help please

Re: Communication help please

Microsquirt no responce

Re: Communication help please

Re: Communication help please

Re: Communication help please

Re: Communication help please

Re: Communication help please