What ignition settings do I use with a microsquirt using a tach input? I have optin+ to coil- and optin- to 12v+ as per megamaual, and I get no signal.
90 degree v twin crank triggered dyna ignition. No cam sync.
set up and wiring for tach input on micrsquirt
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
-
Matt Cramer
- Super Squirter
- Posts: 910
- Joined: Sat Jul 03, 2004 11:35 am
Re: set up and wiring for tach input on micrsquirt
Is the Microsquirt running fuel only, or is it controlling both fuel and ignition?
Matt Cramer at DIY Autotune
Re: set up and wiring for tach input on micrsquirt
I'm trying to run fuel only.
-
Matt Cramer
- Super Squirter
- Posts: 910
- Joined: Sat Jul 03, 2004 11:35 am
Re: set up and wiring for tach input on micrsquirt
Ok, don't use wheel decoding or dual spark in this case, just trigger off one coil.
Matt Cramer at DIY Autotune