Fuel only ign signal hookup
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
Fuel only ign signal hookup
I'm running fuel only. Do i connect my ign signal to pin30 option+ or pin31 option-.
Re: Fuel only ign signal hookup
Offroad buggy with a turbocharged aircooled vw. I run a Msd dist and 6al box. I have a tach adapter hooked up also. My innovate datalogger wouldn't get a clean signal without it.
-
pommie02
Re: Fuel only ign signal hookup
ok slightly different.
every install seems to be different...trial and error.
with mine i used the option +ve to the negative side of the coil and connected the option -ve to earth.
i then had to fit a zener diode the the +ve side to stop the ignition spikes
every install seems to be different...trial and error.
with mine i used the option +ve to the negative side of the coil and connected the option -ve to earth.
i then had to fit a zener diode the the +ve side to stop the ignition spikes