Resistors per Bank of injectors?

For discussing injector selection, manifold modifications, throttle bodies, fuel supply system design and construction, and FIdle valves and IACs.
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
Post Reply
JustinL
Helpful Squirter
Posts: 43
Joined: Tue Nov 22, 2005 6:03 pm
Location: Edmonton

Resistors per Bank of injectors?

Post by JustinL »

If it's at all possible, I'd like to run 1 resistor per injector bank. Can this be done? I have two banks of two 2.6ohm injectors. I think I should be running about an 8 ohm for each injector, but I don't know what should be done for 2 injectors.

Thanks for any advice.

Justin
88 944 Turbo S- MS-II code 2.6 (fuel only)
87 944- MicroSquirt code 2.883j
Top
Matt Cramer
Super Squirter
Posts: 910
Joined: Sat Jul 03, 2004 11:35 am

Post by Matt Cramer »

It should work. You need the total resistance of the circuit to be 3 ohms or more. Two 2.6 ohm injectors in parallel are 1.3 ohms, so a 2.7 ohm or somewhat larger resistor would fit the bill.
Matt Cramer at DIY Autotune
Image
Top
Post Reply

Return to “Injectors, Fuel & Air Supply”