Reluctor and rotor phasing / MS2 setup - REVISED (resent)

This forum is for discussion of MicroSquirt (TM) from Bowling and Grippo. The MicroSquirt information site is at www.usEasyDocs.com
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
Post Reply
Philip Lochner
Helpful Squirter
Posts: 138
Joined: Thu Feb 16, 2006 5:18 am
Location: South Africa

Reluctor and rotor phasing / MS2 setup - REVISED (resent)

Post by Philip Lochner »

Hi Kris
 
I thought the sharing thing was the main idea here! :-)  I learn so much from this that I'm eager to put something of value back in.
 
Yep, the VR sensor is std Rover (Lucas - Prince of Darkness actually) which is pretty much "standard" in that it has two wires (blue and red) and puts out an AC signal increasing in voltage as the revs pick up.
 
Kind regards
Philip Lochner
Posted by email.
Top
Post Reply

Return to “MicroSquirt General Information”