Page 1 of 1
gm 454 tbi
Posted: Tue Nov 01, 2016 9:48 am
by cj599
need help getting a rpm signal to my microsquirt v2.2 all thepages ive searched do not hel i have a 8 pin module what wire do i hook up and what settings do i need to change this shouldnt be this hard to figure out please help
craighpfeiffer@gmail.com or 405 226 1696 please text
Re: gm 454 tbi
Posted: Mon Nov 07, 2016 8:10 am
by Matt Cramer
V2.2? Is this a MicroSquirt Module, or a cased MicroSquirt?
Re: gm 454 tbi
Posted: Mon Nov 14, 2016 1:08 pm
by cj599
has a aluminium body maybe a 2.0 been a while since i opened it up
Re: gm 454 tbi
Posted: Mon Nov 14, 2016 3:55 pm
by cj599
i believe the harness from diyautotune is different than the old harness can anyone tell me how to configure this box and wire it to the hei about to give up
Re: gm 454 tbi
Posted: Tue Nov 15, 2016 6:54 am
by Matt Cramer
If you are not sure of what you have, please post a picture of it.
Re: gm 454 tbi
Posted: Sun Dec 25, 2016 5:56 am
by cj599
i have got the rpm to the microsquirt it is a v2.0 older box i have a start up pulse but after it hits about 500 rpm the injectors shut down is their a video showing how to data log with tuner studio?
Re: gm 454 tbi
Posted: Fri Dec 30, 2016 10:25 am
by Matt Cramer
To get a data log, go to the Data Logging menu and click Start Logging. You will be prompted for a file name. The log starts when you save the file (this is an easy one to get tripped up on as a lot of people expect saving the file to be what you do at the end of the log). Once you have recorded what you need, go to the Data Logging Menu and click Stop.