MicroSquirt.com read only forum (Jan.15,2018)

Hi All,
All the tutorial/youtube info I've seen tells me that when initially setting up TunerStudio and installing an LC-1 wideband hago, you choose 'LC-1 Wideband' from the drop down menu....
All I seem to get in the setup options (ver 2.0.8 ) is Lambda, Narrowband Sensor and Wideband.

Is it enough to just set it to Wideband? Or am I missing a setup stage later on?

Cheers

There are a couple menus where you set this up; the section you're referring to is for the menu under Tools -> Calibrate AFR Table.