MicroSquirt.com read only forum (Jan.15,2018)

I found a bug in the serial comms for 3.8x code that has been there for some time. But it only affects the comms in rare circumstances when the engine is NOT running. I only saw it in alphaN mode. The fix was very minor and it is attached; no new ini file is needed. Nor should you have any problems with msqs, just save the latest one and restore it after the bootload.

Al,

Indrek86 & I are showing incorrect engine speed in TunerStudio with this firmware using a single missing toothed cam wheel & one sensor. Can you look into it please?
3.76 appears to be OK, but 3.83 shows cam speed not engine speed.

Thanks,
Mike