MicroSquirt.com read only forum (Jan.15,2018)

Have a MPX4250ap-ws and cannot find a wiring diagram for the pinout not mounting it on a board just externally is there any place this can be found.

Pin 1 (with the notch) is the 0-5v signal. Pin 2 is GND, pin 3 is +5v. Pins 4-6 are not used. Solder and heat shrink the appropriate wires to the first 3 pins; I would strongly suggest that a 3-4" flying wire be soldered and heat-shrink'd to the other three pins, and then taped or shrunk to the main wires. This will provide greater strength to the overall assembly.

dontz125 wrote:Pin 1 (with the notch) is the 0-5v signal. Pin 2 is GND, pin 3 is +5v. Pins 4-6 are not used. Solder and heat shrink the appropriate wires to the first 3 pins; I would strongly suggest that a 3-4" flying wire be soldered and heat-shrink'd to the other three pins, and then taped or shrunk to the main wires. This will provide greater strength to the overall assembly.

Thnks helps alot.