MicroSquirt.com read only forum (Jan.15,2018)

I want to alter a few resistor values on the VR1 input circuit but half the component numbers on the silkscreen are unreadable due to via's etc.

Could you post up a pic showing what the silkscreen is supposed to look like?

Cheers,

A really is a good idea!

Here it is. I had to make screen shots for the top and bottom half of the board in order to keep enough resolution.. there is a little overlap between the shots but it should be enough to determine component placement.

Here it is for the top half:



And for the bottom-half:



The silkscreen is not 100% perfect, but this should be enough information for component locations...

- Bruce

Bruce,

I have put this as a GIF file here as well: http://www.microsquirtmodule.com/module_silkscrn.gif

Lance.

Lance wrote:Bruce,

I have put this as a GIF file here as well: http://www.microsquirtmodule.com/module_silkscrn.gif

Lance.

Sweet - and you merged the two shots into one nice file that matches up Perfect!

- Bruce