Page 1 of 1
After a couple of Drag strips, the Q1 transistor blew out.
Posted: Sun Sep 03, 2006 4:57 pm
by hzdistributor
I have four 850cc with 2.98oh injectors and the PWM setting in 75%. MS-I with PCB2.2 fuel only Stock code 8x8 tables.
The engine is a 2.0l 8V Turbo Engine in a Full chassis car running 9.67 in the 1/4mile.
Posted: Mon Sep 04, 2006 2:25 am
by jsmcortina
9 sec 4 pot. Nice!
With the V2.2 board you will need the flyback board to reliably drive those injectors. This is a known failure mode and has been addressed in the V3.0 board.
Check out the flyback section of the megamanual.
James
Posted: Mon Sep 04, 2006 3:49 am
by boost junkie
Another option is injector resistors and the high-res code (which will definately help it idle on 850cc w/ a 2.0L). See the MSNS-E dev forum.
Posted: Mon Sep 04, 2006 6:04 am
by racingmini_mtl
A third option is to use peak and hold injector drivers :
http://www.msefi.com/viewtopic.php?t=19661
You can use these with any code be it the standard code or the high-res code. I agree with boost junkie that the high-res code would be a good choice for you.
Jean
Posted: Mon Sep 04, 2006 3:56 pm
by hzdistributor
I'm planning to use a resistor so I let you know guys....