MicroSquirt.com read only forum (Jan.15,2018)

. Am on the megasquirt II configuring pages. Loaded up newest megatune. Cant find the tables for general settings or sensor calibration. Was intending using chrysler sensors.....
Went into settings and tools, but couldnt find the tables(windows). Am running offline to megatune as the megasquirt is not installed yet to get familiar with megatune program.

Intend to use msd6A with v3board megasquirtII. Will use megasquirt for fuel injection solely. The spark will be controlled by MSD 6A by msd distributor and msd coil. Should there then only be comm to megasquirt from pin 25 and pin 7. As the way described for msd 6a in megasquirt.info is if controlling from megasquirt.(wiring diagram v3.0 board)

Hyvarinen,

Did you set MS-II as the CODE_VARIANT and activate the appropriate megasquirt-II.ini file for the code you intend to use?

Lance.

Lance wrote:Hyvarinen,

Did you set MS-II as the CODE_VARIANT and activate the appropriate megasquirt-II.ini file for the code you intend to use?

Lance.

This really wasnt difficult...thanks for helping.