MicroSquirt.com read only forum (Jan.15,2018)

Has anyone tried using epoxy mount aluminum injector bungs in a cast iron manifold.
I am concerned that the difference in expansion between the two materials may cause the epoxy to fail.
I have searched around for steel bungs thinking I could braze them in but no luck so far.

Neal

Has anyone tried using epoxy mount aluminum injector bungs in a cast iron manifold. I am concerned that the difference in expansion between the two materials may cause the epoxy to fail. I have searched around for steel bungs thinking I could braze them in but no luck so far. Neal
-------------------- m2f -------------------- This post is at: http://www.msefi.com/viewtopic.php?p=135553#135553 -------------------- m2f --------------------


Posted by email.