MicroSquirt.com read only forum (Jan.15,2018)

ok im new to megasquirt and i have a MS II 3.0 with a inovatiove lc-1 wide band.
now when im in mega tune on the screen with all the guages my AF gauge is stuck at 11.9. but when i go in to my AF table that large gauge is stuck there to but the spot below the map is reading right i think cuz it moves around where i want it to go for the AFR.
anyone have any ideas whats wrong?

orange88,

When you set up MegaTune, did you use mtCfg.exe to select the LC-1? (http://www.megamanual.com/megatune.htm#installprocess)

Then when in MegaTune, did you calibrate the AFR table to the LC-1? (http://www.megamanual.com/megatune.htm#oa)

Those are the two most likely problems (assuming you activated the corrct INI file for your code).

Lance.