MicroSquirt.com read only forum (Jan.15,2018)

Hope someone can help.

I have an innovate LC1 wideband. When I go to calibrate afr table in MEgatune (MS2 2.672) I can select innovate wb 0-5 V but how do I know how to calibrate the LC1 in the LC1 programmer application since I don't see anywhere in megatune that tells me what afr it is expecting at 0v and what afr it is expecting at 5V.

Regards

Jon

Mine came with one output set to 0-5V already, I believe it's 10:1 at 0V and 20:1 at 5V

Thanks,

I found just some stuff on innovates site:

"The LC-1's analog output 2 is factory programmed to provide a
linear output between 0V and 5V for an AFR of 7.35 to 22.39. Any other linear output range
between 0 and 5V can be programmed. See chapter 6.5: Programming the analog outputs for
details."


but does MS2 assume the LC1 is at its default settings?
Jon

I believe so!

hi
if you chose the rigth wide band in mtcfg, and adjust lc-1 in the sw that comes with it to the rigth value, you should be god to go