Page 1 of 1
cannot get #'s to stick in warmup wizard
Posted: Fri Apr 21, 2006 3:46 am
by brownquirt
MSII 2.34/mt225 V3
as the title says, i cannot get the numbers to stick in the 160* box, all other boxes work....? (it stays at 100)
Posted: Fri Apr 21, 2006 5:59 am
by bluetrepidation
160 is the fully warmed state which should be %100. Can you chage this? I never tried?
Posted: Fri Apr 21, 2006 6:22 am
by Mike Simard
v2.34 won't allow anything other than 100% in the 160 box. Beta versions since 2.54 allow ASE settings for every temperature range including 160, it's a very good feature.
Posted: Fri Apr 21, 2006 3:44 pm
by brownquirt
thanks, i guess i was not understanding how it worked. so the 100= 100% warmed up, I thought it was like +100% adding fuel so it could warmup. thanks for the help, should make a big difference.
