MicroSquirt.com read only forum (Jan.15,2018)

hello i'm building my v3.0 blue board with a msII setup I jumped and dl monitor_v2.35 to the board with no issues I'm just having trouble getting mega tune to work i get a common error

"controller code version does not mach signature in megasquirt-.ini (see audit.log for where the abov file was found.

expected "0x14"(found in ini file)
received "msII rev 2.30000 (from controller)
table corruption may occur... ... ..."

how to I ajust this i tried to activate 2.3x and save but nothing happend please help this newb

Have you renamed the MegaSquirt-II.ini.2.3 to MegaSquirt-II.ini in your MegaTune\mtCfg folder?

If not, do this. Then your MT version should match the firmware version that you uploaded to MS-II (which is 2.35 as you stated).

Cheers,

Tadek

I have seen this happen when the communications parameters were set for for msi and msii processor was being used. IE 9600 instead of 115200 -- also have seen this when when msi was "set" when msii should have been. Check your software setup for megatune.

http://www.megasquirt.info/connect.htm

Start at step 5 to load the code and activate the proper .ini file. That should get you connected and running.