Page 1 of 1
GSXR 600 Injector impedence
Posted: Wed Mar 29, 2006 11:23 am
by MarkW
Hi All,
Newbie with probably a daft question thats been asked before!!
I'm fitting GSXR TBs to a zetec and running a megasquirt, hopefully to be up and running next week.
What I need to know is the impedence of the 600 injectors. Bit new to this but the guys whose helping with the ms was asking.
Cheers
Posted: Fri Mar 31, 2006 1:05 pm
by MarkW
Anyone??
GSXR 600 Injector impedence
Posted: Fri Mar 31, 2006 1:12 pm
by Bernard Fife
Mark,
Â
Measure the DC resistance of the injectors (with an ohmmeter across the two terminals for the connector). This will give you a rough idea of their impedance. If the DC resistance is greater than 10 Ohms, you have high impedance injectors. If the DC resistance is less than 4 Ohms, you have low impedance injectors.
Â
In virtually all cases, this is all you need to know to wire MegaSquirt.
Â
If you want to know the actual impedance, you'll need an LC (or LRC) meter.
Â
Lance.
Posted by email.
Posted: Fri Mar 31, 2006 1:45 pm
by MarkW
Thanks for the help Lance
Posted: Wed Apr 05, 2006 9:12 pm
by ElyasWolff
Did you ever find out if they were high or low impedance?
Posted: Thu Apr 06, 2006 2:01 am
by MarkW
Sticky thread above lists them as 13ohm and high impedence but there's a question mark after this, we are working on the basis that they are high impedence at the moment although I haven't tested them. Hopefully the tB's will be plumbed in today ready to fire it all up tonight. will let you know.