Tach Signal Dont have one
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
-
two stroker
- MegaSquirt Newbie
- Posts: 17
- Joined: Sun Nov 06, 2011 11:09 am
Re: Tach Signal Dont have one
I installed my missing tooth about tdc and set to 36-1 and no cam teeth and rising edge , I played with only two teeth and nothing till I installed 36-1 . I went 12v to red ,sensor ground to chassis and signal wire to vr1 + and left vr1- unhooked, works good to 8500 rpm . Im using micro s 3.0 with 3.770 code which i reloaded a few times while trying to get a signal.