Page 2 of 2
Re: Communication help please
Posted: Thu Jul 22, 2010 9:09 am
by Captain Midnight
It calls it: Communications Port (Com1)
Re: Communication help please
Posted: Thu Jul 22, 2010 9:37 am
by Captain Midnight
The port checker can't see Microsquirt. I have checked the cable.
Re: Communication help please
Posted: Thu Jul 22, 2010 9:41 am
by Captain Midnight
Is there any other way to test. I'm getting nothing.
Microsquirt no responce
Posted: Thu Jul 22, 2010 8:56 pm
by Captain Midnight
I can't get any comunication with Microsquirt. Should I send it back, or is there a way to check it.
Re: Communication help please
Posted: Fri Jul 23, 2010 4:48 am
by Matt Cramer
Please post the text you get when you try to load the firmware on COM1 instead of COM3.
Re: Communication help please
Posted: Sat Jul 24, 2010 1:42 pm
by Captain Midnight
If I set Megatune to port 1, port-checker say it found port 3. If I set Megatune to port 3, port-checker says it found port 1. What is that all about?
Re: Communication help please
Posted: Sun Jul 25, 2010 4:40 am
by mxrob
Have you just tried dumping and reloading code?
Re: Communication help please
Posted: Sun Jul 25, 2010 8:18 am
by Captain Midnight
The instrustions in the manual don't work, so how would you you do that?
Thanks
Re: Communication help please
Posted: Mon Jul 26, 2010 9:11 am
by Matt Cramer
Captain Midnight wrote:If I set Megatune to port 1, port-checker say it found port 3. If I set Megatune to port 3, port-checker says it found port 1. What is that all about?
Don't run MegaTune and Port Check at the same time.