MicroSquirt.com read only forum (Jan.15,2018)

I find repairing SMT stuff is often easier and quicker than through hole ... But you need good eyesight or a magnifier. Also, some of the codes and such on SM stuff are a bit cryptic, and therefore painful to work with. But anything SMT I have built looks shoddy compared with the same thing built by a machine!

I like Scotts idea - I put a standard V3.0 board in an Ford eec -4 case and it was a pain.

Kendall.

Kendall,

Hopefully B&G can deliver a fully built unit without the connector I can use for the "Microsquirt inside" adaptor board. If I get one soon enough I'll bring a completed unit and a few adaptors to Brisbane the next time I'm out, probably the first of the year. I'll take the drive to Toowoomba and you can try it out on the 'Wagon.

Sounds like a plan! Although, at the rate I am modifying my MS box, it might take a bit of tweaking....

Kendall.