Page 2 of 2
Posted: Fri Sep 15, 2006 4:42 pm
by fastfreddie
Here is a picture of starting!
losing RPM signal around 800rpm
Posted: Fri Sep 15, 2006 4:42 pm
by fastfreddie
Here is a picture of starting!
Posted by email.
Posted: Sun Sep 17, 2006 1:25 am
by krisr
Are you capturing on rising or falling edge?
I'm running an MSD pro-billet dist with the VR trigger circuit, rising edge is what i'm using. Your polarity is probably ok if you can get it started & running. I found that reversed polarity would not even trigger.
Posted: Mon Sep 18, 2006 1:51 am
by fastfreddie
Thanks Kris!
It turns out i should have checked it out myself!
The VR trigger isnt' sensitive enough to run older "low" output VR sensors, a day of prodding and comparing led me to that conclusion.
Brgds
Freddie