Choosing compression ratio for pistons.

For discussing MicroSquirt (TM) configuration and tuning of fuel parameters (including idle valves, etc.).
Forum rules
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
Post Reply
Uncle Bob
Helpful Squirter
Posts: 37
Joined: Sun Nov 27, 2005 4:37 pm

Post by Uncle Bob »

I don't have much experience with 2-valve/cyl motorcycles, so I hesitate to comment on it. But like I said, I would still think you could get 10psi safely with 9:1
Ryan
ryan.langford@comcast.net

Two turbo'd bikes and counting
"Life begins at 10psi"
Top
elturbonitroso
Helpful Squirter
Posts: 42
Joined: Thu Jan 05, 2006 7:26 pm
Location: CONNECTICUT

Post by elturbonitroso »

in my engine the factory comp was 10.3.1 and i lower to 9.0.1 and the car spool the turbo very quick and dont lost a lot of power when the engine is not boosting.
Top
Post Reply

Return to “Tuning Fuel and Air”