Controlling edis4 with micro v3
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
Controlling edis4 with micro v3
Hey how's it going .. I'm about to install EDIS 4 on my starion 2.6 motor . Was wondering if any of you had good experience controlling timing advance. Just want to make sure it's straight forward .. Don't want install and be stuck with 10 degrees in limp mode all the time.. Thanks any input would be great ...
Re: Controlling edis4 with micro v3
No takers lol.. I'm sure someone has done this. Thanks for any help. I got my brackets fabed up its going in soon. Wish me luck .
-
Matt Cramer
- Super Squirter
- Posts: 910
- Joined: Sat Jul 03, 2004 11:35 am
Re: Controlling edis4 with micro v3
It is pretty straightforward; did you have any questions about how to set it up?
Matt Cramer at DIY Autotune
Re: Controlling edis4 with micro v3
Hey Matt.. The setup looks pretty straight forward. My only question so far is on diagram it shows pin seven from EDIS module , has a loop around vr wires labeled shield and the same around the saw and pip wires. I'm assuming u shield these wires , but is pin seven a ground that needs to be tapped together in with shield? Thanks
-
Matt Cramer
- Super Squirter
- Posts: 910
- Joined: Sat Jul 03, 2004 11:35 am