Phasing injectors
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
Phasing injectors
Is it possible to phase the two banks of injectors with microsquirt? I want to set injectors at two distances from the inlet valve for low and high rpm fuelling.
-
24c
- Master Squirter
- Posts: 593
- Joined: Sat Feb 16, 2008 12:15 pm
- Location: Chorley, Lancashire UK
- Contact:
Re: Phasing injectors
Hi Steven,
This is called Staged Injection, and it part way down the link. You can also find other references outside this forum. The only proviso is you want higher impedance injectors.
However, because of your question, I think you're probably talking about a motorcycle engine, and the request is similar to what some OEMs use, you'll already have higher impedance injectors.
Mike
This is called Staged Injection, and it part way down the link. You can also find other references outside this forum. The only proviso is you want higher impedance injectors.
However, because of your question, I think you're probably talking about a motorcycle engine, and the request is similar to what some OEMs use, you'll already have higher impedance injectors.
Mike
Re: Phasing injectors
Thanks for the info, I'm on a steep learning curve. The engine is a Chevrolet inline 250 and because I'm using parts from a worn out LS truck v8 so I have enough parts to get creative.