My problem is timing at the crank is going from 22.3 deg. to 36 deg. but my spark table is set 22.3 deg across the board.
any ideas? I was thinking the MSD TFI module is programed this way.
using TunerStudio MS lite 2.08 and the microsquirt is 3ish years old. the long block and distributer has 50+ miles, like not broke in yet.
Ford MSD TFI distributer advancing with flat spark table.
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
-
caprigsturbo
- MegaSquirt Newbie
- Posts: 1
- Joined: Sat Jul 06, 2013 5:54 pm
-
Matt Cramer
- Super Squirter
- Posts: 910
- Joined: Sat Jul 03, 2004 11:35 am
Re: Ford MSD TFI distributer advancing with flat spark table
Can you post a copy of your MSQ and a data log of the problem?
Matt Cramer at DIY Autotune
