Just did an update of the firmware on my MicroSquirt v2 to Megasquirt Extra V 3.2.4. The update seemed to go fine but when I went to run Megatunix it did not recognise the firmware. I updated to the latest version of Megatunix via git today (26 November 2012), but that did not resolve the issue.
What could be the problem? I tried to find a firmware downgrade to Extra V 3.2.1 as Megatunix supports 3.2.1 (but perhaps not 3.2.4 yet?) but was unable to locate a download link.
Anybody able to help? Thanks all.
Firmware update - Megatunix not recognising firmware
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
-
anonymous.shyster
- Helpful Squirter
- Posts: 75
- Joined: Fri Oct 21, 2011 9:46 pm