ms wont datalog??

[isaacson06]

So ive finally got ms talking with my laptop the only problem now is it wont read any of my sensors i have the tps hooked up but it wont read but if i turn the power off and hold the throttle open then turn power back on it will read where its at when the power gets turned back on but if you let off throttle it just says where it was ??? its like the computer talks once to the ms and then doesnt read anymore but the tunerstudio says good connection. any help would be great thanks

[Bernard Fife]

issacson06,

Usually this is caused by one of two things:

- the incorrect INI file is being used. This kills the serial communications after a short while, and the returned values appear to freeze. So make sure you are using the correct INI (more here: http://www.useasydocs.com/details/usv3code.htm )

- Your serial communications aren't reliably: Check these tips: http://www.useasydocs.com/details/connect.htm

Lance.

[isaacson06]

now the ini file do i just copy and paste that in tuner studio ?

[Bernard Fife]

See steps 11 to 14 in the first link above.

[isaacson06]

Thanks lance I've tried loading the new enbbed code and now I can't get that to load so now when I try to connect to the ms it says it's found it on com1 but theres no firmware loaded ?? I tried to do just the ini file with no luck. So now back to the enbbed code I'm hooked up though USB to serial is that a problem ? Lance thanks again for your help

[isaacson06]

well lance after i came in a had dinner and wrote the post above i went outside to try just one more time for the night well IT WORKS i cant thank you enough i have posted in here a couple of time with none wanting to help me but u did and i thank you i should be trying to fire it up in the next day or so. thanks again