EGT on Ms

Forum for discussing how to install MicroSquirt(TM), choose and troubleshoot sensors, wiring, and communications for MicroSquirt (TM) and MicroSquirt Module(TM).
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
Post Reply
DanMan68
MegaSquirt Newbie
Posts: 1
Joined: Wed Oct 15, 2008 2:23 pm

EGT on Ms

Post by DanMan68 »

Is this possible? I did not see a port for one on the wireing page. Am I missing somthing? Also on another note, if anyone knows of a good place to get flex fuel sensors that would be appreciated as well.
Top
Matt Cramer
Super Squirter
Posts: 910
Joined: Sat Jul 03, 2004 11:35 am

Re: EGT on Ms

Post by Matt Cramer »

If you had a device that converted the signal from an EGT probe to a 0-5 volt signal, you could bring it in over the Spare ADC wire. You'd have to make a couple changes to MegaTune's INI files in order to log it correctly.
Matt Cramer at DIY Autotune
Image
Top
Post Reply

Return to “Installation, Wiring and Sensors”