Help! Just updatet the software and now...

Tobisen · Post by **Tobisen** » Mon Mar 03, 2008 7:18 am

Just uodatet the software to the new 2.883j and now the fuelpump is driving on and off all the time!
The TPS is no longer variable!

What happend?

I am a newbee here, and have not started uo the engine yet...

Post by **grippo** » Mon Mar 03, 2008 7:53 am

You have to enter the cpu type - under "General" on the first or second pulldown menu - about the only thing that is not greyed out. Once you do this you will have the defaults and all will go back to normal. The purpose of this was to ensure the processor knows what board it is embedded in so it doesn't flood your engine or burn out your coil drivers. Better to give you a heart attack than hurt the engine right ?

Tobisen · Post by **Tobisen** » Mon Mar 03, 2008 7:58 am

Thanks:)

gun_hawk · Post by **gun_hawk** » Mon Mar 03, 2008 6:50 pm

I have the same problem . I selected 2 for microsquirt but my TPS only goes from 0 to 1 percent.

any help would be appreciated.